was successfully added to your cart.

Day 95: Proto work and yo-yo displays

By February 3, 2017Vlogs

I spent some time talking about the protos and this idea I’ve had recently for yo-yo displays and the designs I’ve thought of so far.

One Comment

  • Wayne Dowler says:

    Next run of throws – you need to adjust the bearing seat width enough to get bearings in easily! Impossible to do it by hand and be totally accurate. Must not be that much of an adjustment if a bit of sanding will fix it. Bring a good representative bearing or two with you to the machine shop and they can put a caliper on it, then adjust seat width to allow for easy install/removal. Probably needs only a few thousandths adjustment and shouldn’t affect overall weight very much. IMO of course

Leave a Reply